ZyXEL Communications EMG8726-B10A User Manual page 73

Table 12 Network Setting > Broadband > Add New WAN Interface/Edit (Routing Mode) (continued)
LABEL
Primary DNS
Server
Secondary DNS
Server
OK
Cancel
6.2.1.2 Bridge Mode
Click the Add new WAN Interface in the Network Setting > Broadband screen or the Edit icon next to the
connection you want to configure. Select Bridge as the encapsulation mode. The screen varies
depending on the interface type you select.
If you select Ethernet as the interface type, the following screen appears.
Figure 27 Network Setting > Broadband > Add New WAN Interface/Edit (Ethernet-Bridge Mode)
The following table describes the fields in this screen.
Table 13 Network Setting > Broadband > Add New WAN Interface/Edit (Ethernet-Bridge)
LABEL
General
Active
Name
Type
Mode
VLAN
Chapter 6 Broadband
DESCRIPTION
Enter the first IPv6 DNS server address assigned by the ISP.
Enter the second IPv6 DNS server address assigned by the ISP.
Click OK to save your changes back to the EMG.
Click Cancel to exit this screen without saving.
DESCRIPTION
Select Enable to enable this WAN interface.
Enter a service name of the connection.
Select Ethernet as the interface that you want to configure.
Select Bridge when your ISP provides you more than one IP address and you want the connected
computers to get individual IP address from ISP's DHCP server directly. If you select Bridge, you
cannot use routing functions, such as QoS, Firewall, DHCP server and NAT on traffic from the
selected LAN port(s).
EMG6726/8726-B10A User's Guide
73