Dell EqualLogic PS6210 Hardware Owner's Manual page 34

PS6210 Hardware Owner's Manual
Set the screw aside before you remove the cover; otherwise, the screw might fall inside the control
module. If this occurs, you might have to return the control module to Dell for servicing.
4. Using the screw tab as a handle, swing the battery cover up and to the left and lay it upside down
on the control module
battery is attached to the cover.
5. The connector that connects to the battery unit is held in place by a retaining clip, which must be
depressed to remove the connector, as shown in
while simultaneously depressing the retaining clip, and wiggle the connector gently side to side
while pulling outward to remove it. Set the old battery unit aside.
28
(Figure 25). The battery cover will be heavier than expected because the
Figure 25: Removing the Battery Cover
Figure 26: Disconnecting the Battery
3 Maintaining Control Modules
Figure 26. Grasp the outside of the connector,