Dell EqualLogic PS6210 Hardware Owner's Manual page 23

PS6210 Hardware Owner's Manual
Table 6: Ethernet and Management Port LED Descriptions
Ethernet LED
State
Location
Off
Top (Link)
On (green)
Off
Bottom (Act)
On (amber)
10GBASE-T
Ethernet
LED Location
Off
Left (Link)
On (green)
Off
Right (Act)
On (amber)
SPF+ Ethernet
State
LED Location
Off
Top (Link)
On (green)
Off
Bottom (Act)
On (amber)
Management
State
LED Location
Off
Left (Link) On (green)
On (amber)
Off
Right (Act)
On (blinking green)
Table 7: Control Module Status LED Descriptions
LED Name State
Off
PWR
On (steady
green)
Off
Steady red
ERR
Blinking red
Figure 17: Control Module LEDs
State
Description
No power.
Power/OK.
Normal operation or no power.
Array is starting up, in error condition, in Standby mode, or returning from
Standby mode.
Array is entering power standby mode because the Standby On/Off button
was pressed.
3 Maintaining Control Modules
Description
No power or not connected to network.
Connected to network.
No power, not transmitting, or not receiving.
Transmitting or receiving.
Description
No power, not connected to network, or passive.
Connected to network.
No power, not transmitting, or not receiving.
Transmitting or receiving.
Description
No power, not connected to network, or passive.
Connected to network.
No power, not transmitting, or not receiving.
Transmitting or receiving.
Description
No power or not connected to network.
Connected to network (100mbit).
Connected to network (10mbit).
No power, not transmitting, or not receiving.
Transmitting or receiving.
17