Dell EqualLogic PS6210 Hardware Owner's Manual page 19

PS6210 Hardware Owner's Manual
4. Push the drive completely into the slot (callout 2). The drive handle will begin to close onto the
drive (callout 3).
5. Push in the handle until you hear a click (callout 4).
Verify that the new drive is operational by examining the LEDs on the front panel, as described in
Interpreting Drive LEDs on page
member select show disks
Removing a Drive Blank
To maintain proper system cooling, all empty drive slots must have drive blanks installed.
1. Remove the bezel. See
2. Press the release tab and slide the drive blank out until it is free of the drive slot. See
Figure 15 and the callouts
Figure 13: Installing a 3.5-inch Drive
7. In addition, examine the GUI Member Disks window and the CLI
command output.
Removing the Bezel on page
in.Table 5.
2.
2 Maintaining Drives
Figure 14 or
13