Dell EqualLogic PS6210 Hardware Owner's Manual page 18

PS6210 Hardware Owner's Manual 2 Maintaining Drives
Removing a 3.5-inch Drive
1. Remove the bezel. See Removing the Bezel on page 2.
2. Press the release button (callout 1 in Figure 12). The drive latch opens and the drive emerges
partway from the array (callout 2).
3. Pull the drive out by the handle until it is free of the drive bay (callout 3).
Figure 12: Removing a 3.5-Inch Drive
Installing a 3.5-inch Drive
The 3.5-inch drives are installed horizontally, with the drive release latch to the left and the drive
label to the right.
1. Wear electrostatic protection when handling a drive. See Protecting Hardware on page 1.
2. Open the drive release latch.
3. Hold the drive by the carrier and slide the drive most of the way into a slot (callout 1 in Figure 13).
12