Back-Panel Features And Indicators - Dell EqualLogic PS6210 Hardware Owner's Manual

PS6210 Hardware Owner's Manual
Figure 4: Front-Panel Features and Indicators (2U Array)
Figure 5: Front-Panel Features and Indicators (4U Array)
Item Indicator Icon
Array status
1
LED
2 Power LED
Drive release
3 None
latch
The LEDs are part of a built-in chassis control panel that is not hot-swappable and can be replaced
only by support personnel. During the array power-up sequence, these LEDs will cycle through
different states until the array is fully started and the active control module has been determined.

Back-Panel Features and Indicators

The back of a PS6210 with AC power is shown in
Table 2 describes the back-panel features.
4
Table 1: Front-Panel Feature Descriptions
Description
The array status LED lights when the array power is on.
• Off—No power.
• Steady blue—Array status is OK.
• Slow blinking blue—Array status is Standby mode.
• Blinking blue—Administrator request to identify the array (see the Group
Manager online help).
• Steady amber—Critical status.
• Blinking amber—Warning.
The power LED is ON when at least one power supply is supplying power to
the array.
• Off—No power, or the array is in Standby mode.
• Steady green—Array has at least one power supply providing power, and
array is not in Standby mode.
Enables you to remove a drive from the array.
1 Basic Storage Array Information
Figure 6 and Figure 7.