Dell EqualLogic PS6210 Hardware Owner's Manual page 41

PS6210 Hardware Owner's Manual
1. Hold the power supply module so that the orange release latch is on the upper left.
2. Slide the power supply and cooling module into the chassis until it is fully seated and the release
latch clicks into place, as illustrated in
Before the power cable is connected, the fans start spinning, powered by the other power supply
module.
Figure 32: Inserting a 700W Power Supply and Cooling Module
Figure 33: Inserting a 1080W Power Supply and Cooling Module
3. Ensure the power switch is in the OFF position.
4. Connect the power cable to the power supply and cooling module and plug the cable into a power
outlet.
4 Maintaining Power Supply and Cooling Modules
Figure 32 and Figure 33.
35