TP-Link TL-WPA8730 User Manual page 13

Chapter 2
Done!
Q & A:
2 Join the new powerline extender into the existing powerline
network by pairing two powerline devices.
a . Press the Pair button on the existing powerline extender
for 1 second. The Power LED starts blinking.
Note: If the Power LED does not blink, press again.
b . Within two minutes, press the Pair button on the new
powerline extender for 1 second. The Power LED starts
blinking. When the Powerline LED stays on, the pairing
process is done!
3 Relocate the new powerline extender to a wall socket at
where Wi-Fi is preferred.
Note: A red Powerline LED indicates poor signal strength, we recommend
another location.
Now enjoy the Internet! The SSID and password are the same as
that of your old wireless network!
If you still don't have wireless signals near the new extender, it
is possibly you haven't paired your old powerline devices. We
recommend you follow the steps below to pair them. Please
note that Pair can only be used on two devices at a time.
1 Press the Pair button on the old powerline extender for 1
second. Then its Power LED starts blinking.
Existing Powerline Extender
Powerline
Initial Use
New Powerline Extender
10