TP-Link TL-WPA8730 Manual

TL-WPA8730
Hello, I'm here.
Follow me to extend your Wi-Fi network.
e
r l i n
New Extender
w e
P o TL-WPA8730
1
Plug in the new extender next to one of your
existing powerline devices.
2
Check the new extender's Powerline LED
> Step 4
> Step 3
Existing Powerline Device
(For demonstration only)
. Is it on?
3
Pair the powerline devices.
A Press the Pair button on the existing B Within 2 minutes, press the
powerline device for 1 second. The Pair button on the new
Power LED starts blinking. extender for 1 second. The
Power LED
Note: If the Power LED does not
blink, press the Pair button again.
Blinking
within 2 minutes
Existing
Powerline Device
4
Relocate the new extender to the Wi-Fi "dead"
zone. Use the SSID (network name) and password
on the provided Wi-Fi Info Card to connect to the
internet.
Note: A red Powerline LED indicates poor signal strength.
Move the extender to another location.
If you cannot find the SSID on the Info card in your
Wi-Fi list, this may mean the Auto-Sync feature
has automatically copied over the existing
wireless settings (see back for more information).
In this case, use the SSID and password of your
existing wireless network to connect.
C When the Powerline LED on
the new extender turns solid,
the pairing process is complete.
starts blinking.
Blinking
On
New Extender
TL-WPA8730