TP-Link TL-WPA8630P Quick Installation Manual

Quick Installation Guide
TL-WPA8630P
* TL-WPA8630P (European version) is used for demonstration in this guide.
e
r l i n
w e
P o
New Extender
TL-WPA8630P
1
Plug in the new extender near one of your existing powerline devices.
2
Check the new extender's Powerline LED
> Step 4
> Step 3
Existing Powerline Device
(for demonstration only)
. Is it on?
3
Pair the powerline devices.
A Press the Pair button on the existing powerline
device for 1 second. The Power LED starts blinking.
Note: If the Power LED does not blink, press the Pair
button again.
Blinking
Within 2 minutes
Existing Powerline Device
4
Relocate the extender to the Wi-Fi "dead" zone.
Connect your devices to the internet using the
default SSID (network name) and password on
the Wi-Fi Info Card provided.
Note: If the Powerline LED turns red, it means the signal
strength is poor. Try another wall outlet.
If you cannot find this SSID in your Wi-Fi network list, this may mean the Wi-Fi Move feature
has automatically copied over the existing wireless settings (see back for more information).
In this case, use the SSID and password of your existing powerline network to connect.
Attention
Plug powerline devices into wall outlets instead of power strips.
Wall Outlet
B Within 2 minutes, press the Pair button on the new
extender for 1 second. The Power LED starts blinking.
When the Powerline LED on the new extender turns
on, the pairing process is complete.
Blinking
On
New Extender TL-WPA8630P
TP-Link_XXXX
TP-Link_XXXX_5G
SSID: TP-Link_XXXX
SSID: TP-Link_XXXX_5G
Wireless Password: XXXXXXXX
Power Strip