MULTIQUIP WBH-16F Operation And Parts Manual page 23

RECOIL START (METHOD)
1. Follow steps 1 through 6 of the Electric Start procedure.
2. Place the Engine ON/OFF switch (Figure 17) in the
ON position.
ENGINE SWITCH
Figure 17. Engine ON/OFF Switch (Recoil Start)
3. Grasp the starter grip (Figure 18) and slowly pull it
out. The resistance becomes the hardest at a certain
position, corresponding to the compression point. Pull
the starter grip briskly and smoothly for starting.
STARTER GRIP
Figure 18. Starter Grip
NOTICE
DO NOT pull the starter rope all the way to the end.
DO NOT release the starter rope after pulling. Allow it
to rewind as soon as possible.
4. After the engine has started and warmed, place the
choke lever in the OPEN position.
5. If the engine has not started, repeat steps 1 through 3.
PAGE 22 — WBH-16 SERIES POWER BUGGY • OPERATION AND PARTS MANUAL — REV. #2 (09/12/19)
OFF
OR
ON
(NO BATTERY)
PRE-CHECK
1. Engage the parking brake lever (Figure 19) and attempt
to rock the buggy back and forth. If the wheels turn
during the rocking motion, adjust the brakes as outlined
in the maintenance section of this manual.
Figure 19. Parking Brake Lever
2. Place the engine's throttle lever (Figure 15) in the slow
(idle) position.
3. Check the speed control lever (Figure 20) located on
the right side of the handle bar. The speed control
should work freely when squeezed by hand, and return
to the neutral position when released.
Figure 20. Speed Control Lever
OPERATION
PARKING
BRAKE
(SET)
RELEASED
SPEED
CONTROL
LEVER