MULTIQUIP WBH-16F Operation And Parts Manual page 22

6. If starting a warm engine or the temperature is warm,
place the choke lever (Figure 14) in the OPEN position.
CHOKE
LEVER
CLOSE
Figure 14. Engine Choke Lever (Open)
7. Move the throttle lever halfway between the FAST and
SLOW position (Figure 15) for starting.
THROTTLE
LEVER
Figure 15. Throttle Lever
WBH-16 SERIES POWER BUGGY • OPERATION AND PARTS MANUAL — REV. #2 (09/12/19) — PAGE 21
OPEN
FAST SLOW
8. Place the ignition key (Figure 16 ) in the START position
and hold it until the engine starts. When the engine
starts, release the key, allowing it to return back to the
ON position.
Figure 16. Engine ON/OFF Switch
(Electric Start Models)
9. Make sure the choke lever has been placed in the
OPEN position (Figure 14) before operating the power
buggy.
10. Place the throttle lever in the FAST position
11. Before the buggy is placed into operation, run the
engine for several minutes. Check for fuel leaks, and
noises that would associate with a loose guard or cover.
OPERATION