MULTIQUIP WBH-16F Operation And Parts Manual page 10

Power buggy
Hide thumbs Also See for WBH-16F:
Table of Contents

Advertisement

„ ALWAYS recharge the battery in a well-ventilated
environment to avoid the risk of a dangerous concentration
of combustible gases.
„ If the battery liquid (dilute sulfuric acid)
comes into contact with clothing or skin,
rinse skin or clothing immediately with
plenty of water.
„ If the battery liquid (dilute sulfuric acid) comes into
contact with eyes, rinse eyes immediately with plenty
of water and contact the nearest doctor or hospital to
seek medical attention.
CAUTION
„ ALWAYS disconnect the NEGATIVE battery terminal
before performing service on the equipment.
„ ALWAYS keep battery cables in good working condition.
Repair or replace all worn cables.
LIFTING SAFETY
CAUTION
„ NEVER allow any person or animal to stand underneath
the equipment while lifting.
NOTICE
„ When lifting of the power buggy is required, use a
properly rated forklift. Forklift pockets are provided on
the power buggy's frame. Make sure the forklift arms are
insert into the power buggy's fork lift pockets a minimum
of 24-inches. Before lifting, make sure that the lifting bale
is not damaged.
„ NEVER tip the engine to extreme angles during lifting as
it may cause oil to gravitate into the cylinder head, making
the engine start diffi cult.
„ DO NOT lift machine to unnecessary heights.
„ NEVER lift the equipment while the engine is running.
„ ALWAYS use ramps capable of supporting the weight
of the power buggy and the operator to load and unload
the power buggy.
WBH-16 SERIES POWER BUGGY • OPERATION AND PARTS MANUAL — REV. #2 (09/12/19) — PAGE 9
SAFETY INFORMATION
TRANSPORTING SAFETY
NOTICE
„ ALWAYS shutdown engine before transporting.
„ Tighten fuel tank cap securely and close fuel cock to
prevent fuel from spilling.
„ When transporting of the power buggy is required, place
the power buggy on a fl at bed truck or equivalent and
tie down securely.
„ ALWAYS make sure all tie-downs and block are in
place and the bucket is completely lowered in the fl at
(horizontal) position and securely latched.
„ Place chock blocks underneath wheel to prevent rolling.
„ When transporting the power buggy on a truck or trailer,
know the overall height to avoid contacting overhead
obstructions such as bridges and power lines. Check
the truck and ramp capacities.
„ ALWAYS place the fuel valve lever in the OFF position
when the before transporting.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Wbh-16Wbh-16eWbh-16efWhiteman series

Table of Contents