Battery Status Lights; Maintenance Requirement Lights - Ilsco TASKMASTER TOOLS TB-CUT40CU-IS Instruction Manual

BATTERY STATUS LIGHTS

Fault
At the end of the cutting cycle
No light
Red flashing light
Red light
After inserting the battery
Green light
Red light

MAINTENANCE REQUIREMENT LIGHTS

Fault
At the end of the cutting cycle
green light
green/red flashing
red flashing
red light
orange light
After inserting the battery
green light
orange light
Tool Reset:
The cable cutter turns off and remains blocked. The service red or orange LED's light up.
Work can resume only after replacing the battery or after removing it for a moment and
then reinserting it. If, after you reset the tool, the issue persists contact the customer
service department (see back cover).
16
Cause / Solution
No malfunction
Charge / substitute the battery (about 10% of the capacity)
Flat battery
No malfunction
Charge /replace the battery
Cause / Solution
Operating value OK
Operating value OK and interval of maintenance passed/due
Operating value at limit / contact customer service
Operating value faulty or hardware malfunction / request
assistance
Temperature error / warm or cool the tool
No malfunction
Temperature error / warm or cool the tool
TB-CUT40CU-IS