Table of Contents
Advertisement
TB-CUT40CU-IS
ADVANCE TRIGGER AND RELEASE BUTTON
1.
The cutting head jaws move together when the advance trigger is pressed and stops when
the trigger is released.
2.
To release the cutting head jaws, press the release button.
CUTTING
1.
Retract the cutting head jaws fully by pressing the release button.
2.
Place the wire between the cutting head jaws. Make sure all cuts
are made perpendicular to the cutting head.
3.
Press the advance trigger to start the cutting cycle.
4.
Once cutting cycle is complete, the cutting head jaws will release back to their open position.
5.
Your tool is equipped with SmartCut, once a cut is made pressure stops building and
retraction is automatic, saving time, battery life, and other components.
NOTE: If advance trigger is held down after cut is made, the tool will continue to max pressure.
TOOL MAINTENANCE
Daily maintenance:
•
Use a soapy cloth to wipe away any oil that may be on the housing of the tool.
•
After each cutting cycle wipe the cutting head jaws free of metal shavings.
•
Wipe down all steel parts with WD-40.
•
Store the tool in a non-humid environment.
The tool should provide many years of service when given the proper maintenance and care.
Should you experience any difficulty with the operation and maintenance of this tool, contact
our customer service department (see back cover).
1
2
15
Advertisement
Table of Contents
