Advertisement
Installation
7. Turn on the power to the DisplayPort source.
8. The RJ45 (orange) LED will illuminate on the local transmitter
unit and the DATA (green) LED on the remote receiver unit
will blink to indicate a signal is being received from source
to display. The screen should now display on the connected
monitor.
Optional: Connect the included IR-OUT cable to the transmitter
unit's IR-OUT port. Place the sensor on the IR-OUT cable in
an unobstructed area within clear view of the device being
controlled. Then connect the included IR-IN cable to the receiver
unit's IR-IN port. The IR-IN cable will communicate the desired
command via the transmitter's IR-OUT cable.
Note: The IR-OUT cable receives the signal from the remote control and
sends it to the device being controlled (e.g. Blu-ray™ player, etc.).
27
Advertisement
