Advertisement
Installation
1. Using a DisplayPort 1.2 cable (such as Tripp Lite P580-Series
4K/60 Hz DisplayPort cables), connect the DisplayPort source
to the INPUT port on the local transmitter unit.
2. Optional: Using an HDMI 2.0 cable (such as Tripp Lite
P569-XXX-CERT or P568-XXX-2A Series cables), connect a
local monitor to the LOCALOUT port on the B127A-1A1-FDFH
local transmitter unit.
3. Using Cat6 cable, connect the RJ45 port on the local
transmitter unit to the RJ45 port on the remote receiver unit.
Optional: For extended transmission distance, connect a
B127A-010-H signal booster between the transmitter and
receiver (sold separately, see tripplite.com).
4. Using an HDMI 2.0 cable (such as Tripp Lite P569-XXX-CERT
or P568-XXX-2A Series cables), connect the remote receiver
unit's HDMI port to the monitors.
5. Turn the power on to your connected TVs/monitors.
6. Connect the external power supply to the local transmitter
unit and plug it into an available wall outlet or (optional) a
Tripp Lite Surge Protector, Power Distribution Unit (PDU) or
Uninterruptible Power Supply (UPS). The DATA (green) LED on
the local transmitter unit will illuminate to indicate the unit
is receiving power from the external power supply. The DATA
(green) LED on the remote receiver unit will illuminate to
indicate the unit is receiving power from the local transmitter
unit through PoC technology.
20
Advertisement
