Tripp Lite B127A-1A1-FHFH Owner's Manual page 18

4k a/v over cat6 wall-plate extender kits and receivers

Installation

Optional: Connect the included IR-OUT cable to the transmitter

unit's IR-OUT port. Place the sensor on the IR-OUT cable in

an unobstructed area within clear view of the device being

controlled. Then connect the included IR-IN cable to the receiver

unit's IR-IN port. The IR-IN cable will communicate the desired

command via the transmitter's IR-OUT cable.

Note: The IR-OUT cable receives the signal from the remote control and

sends it to the device being controlled (e.g. Blu-ray™ player, etc.).

Table of Contents