Advertisement
Installation
4. Using an HDMI 2.0 cable (such as Tripp Lite P569-XXX-CERT
or P568-XXX-2A Series cables), connect the remote receiver
unit's HDMI port to a monitor.
5. Turn the power on to your connected TVs/monitors.
6. Connect the external power supply to the local transmitter
unit and plug it into an available wall outlet or (optional) a
Tripp Lite Surge Protector, Power Distribution Unit (PDU) or
Uninterruptible Power Supply (UPS). The POWER (green)
LED and RJ45 (green) LED on the local transmitter unit will
illuminate to indicate the unit is receiving power from the
external power supply. The DATA (green) LED on the remote
receiver unit will illuminate to indicate the unit is receiving
power from the local transmitter unit through PoC technology.
7. Turn on the power to the HDMI source.
8. The RJ45 (orange) LED will illuminate on the local transmitter
unit and the DATA (green) LED on the remote receiver unit
will blink to indicate a signal is being received from source
to display. The screen should now display on the connected
monitor.
Optional: Connect the included IR-OUT cable to the transmitter
unit's IR-OUT port. Place the sensor on the IR-OUT cable in
an unobstructed area within clear view of the device being
controlled. Then connect the included IR-IN cable to the receiver
unit's IR-IN port. The IR-IN cable will communicate the desired
command via the transmitter's IR-OUT cable.
Note: The IR-OUT cable receives the signal from the remote control and
sends it to the device being controlled (e.g. Blu-ray™ player, etc.).
24
Advertisement
