Table of Contents
Advertisement
102 Diagnostics
Table 55: Blink Code Table for the I/O LED Signaling, Error Code 1
Error code 1: "Hardware and configuration error"
Error
Argument
8
9
10
11
12
14
Table 56: Blink Code Table for the I/O LED Signaling, Error Code 2
Error Code 2: "Exceeded Process Image"
Error
Argument
1
2
Manual
Version 2.0.1
Error Description
Solution
Invalid hardware-
1.
firmware
2.
combination.
3.
1.
Invalid check sum in
2.
the serial EEPROM.
3.
1.
Serial EEPROM
2.
initialization error
3.
1.
Fault when reading in
2.
the serial EEPROM.
3.
Timeout during
1.
access on the serial
2.
EEPROM
3.
1.
Maximum number of
2.
gateway or mailbox
modules exceeded
3.
Error Description
Solution
Not used
Process image is
1.
too large.
2.
3.
750-325 CC-Link Fieldbus Coupler
Turn off the power supply for the node.
Replace the fieldbus controller.
Turn the power supply on again.
Turn off the power supply for the node.
Replace the fieldbus controller.
Turn the power supply on again.
Turn off the power supply for the node.
Replace the fieldbus controller.
Turn the power supply on again.
Turn off the power supply for the node.
Replace the fieldbus controller.
Turn the power supply on again.
Turn off the power supply for the node.
Replace the fieldbus controller.
Turn the power supply on again.
Turn off the power for the node.
Reduce the number of corresponding modules to a valid
number.
Turn the power supply on again.
Turn off the power supply of the node.
Reduce number of I/O modules.
Turn the power supply on.
WAGO-I/O-SYSTEM 750
-
Advertisement
Table of Contents
