Allen-Bradley 1609 Installation Instructions Manual page 2

2 Bulletin 1609 Industrial Uninterruptible Power Supply
Batteries Wiring and Installation Instruction for the UPS
Only use battery wires that have been provided with the UPS.
Warning: Do not service the 1609-SPD without disconnecting the power sources due to electric shock harzard for risk of
severe injury or death.
1. To access the battery compartment
remove the three screws and the
battery door.
3. Fold the battery container and seal it with tape.
4. To connect the batteries to the UPS, insert the batteries into the battery compartment, open the white
connector retainer and connect the two cables together as shown in the photo below.
2. Remove the battery container, jumper and wire harness
Publication 1609-IN013B-EN-P - August 2012
from the battery compartment. Place the battery
container and batteries onto a flat surface. Use the
provided jumper wire to connect the batteries in series.
Connect the positive terminal (red) of the battery to the
negative terminal (black) of another battery. Connect
the red wire of the harness to the positive terminal (top
red) and the black wire of the harness to the negative
terminal (bottom black). See photo below for details.
Black
Red
DIR 10000234490 (Version 01)
Red
Black
Notch
End