Symbols And Markings; Parts And Operating Controls - Bosch MMBH6 TW Series Instruction Manual

Symbols and markings

Symbol Meaning
Do not expose the blender
jug to temperatures above
80°C.
Warnings on the lid
■ Do not use the appliance
unless this cover is
correctly attached.
■ Do not expose the blender
jug to temperatures above
80°C.
Warning on the motor block
■ Do not operate without
the rubber pad.
Parts and operating
controls
High-speed motor block
The blender is equipped with a high-speed
motor with a motor speed of up to 43000
revolutions per minute.This not only
provides particularly fast and fine blending
results but also makes it possible to heat
food. Using the
programme, for example, a hot soup can be
made from cold ingredients.
(max) speed setting, the
Note: At the
blender runs at the highest speed when
(Pulse) button and with
using the
/
certain automatic programmes. In order to
prevent unwanted heating of food, process
the ingredients for a shorter time or at a
lower speed.
/
(on/off) switch
To switch the appliance on and off.
(Soup) automatic
Symbols and markings
Status display
To display the appliance status and as
a mark for the zero setting of the rotary
selector.
Display
Display lights up: appliance is switched
on and ready for use
Display flashes:
– fault in the appliance
– Blender jug is not correctly positioned
or has become detached
– Rotary selector not at zero setting
when switched on
– after interruption of the power supply
– longer than 5½ minutes of continuous
operation (manual mode)
Rotary selector
For continuous adjustment of the blender
knife speed.
Settings
Zero setting (mark points to the status
display) = standstill
Lowest speed
(min)
(max) Highest speed
Caution!
When the appliance automatically turns off
after 51/2 minutes of continuous operation
(max) speed setting, only use
at the
(max) speed setting for another
the
1-2 minutes at the most after turning the
machine back on. Otherwise, the food
may heat up too much and damage the
container.
Notes:
– The status display flashes if the rotary
selector is not at the zero setting when
switched on, if the blender jug has
become detached, or if the electricity
supply has been interrupted. Turn the
rotary selector first to the zero setting
and then continue.
– The rotary selector setting does not
affect the use of the
function.
en
(Pulse)
/
13