Use - Bosch MMBH6 TW Series Instruction Manual

en

Use

(Pulse) button
/
For switching to the maximum speed
for a short time. The appliance works at
maximum speed while the
button is pressed.
Note: The function cannot be used while an
automatic programme is running.
Programme selection buttons
with LEDs
For selecting and starting automatic
programmes. X "Automatic programmes"
see page 16
All LEDs light up after switching on. The
selected programme will start after pressing
the button and the appliance will run
automatically.
Blender jug
For processing up to 2 litres of food. The
blender jug is made of Tritan. Tritan is an
unbreakable plastic with no discernable
taste or smell.
Caution!
Do not expose the blender jug to
temperatures above 80°C.
Lid with locking cap
To securely close the blender jug
during processing. To add chopped or
liquid ingredients, turn the locking cap
anticlockwise and remove.
Pusher
To push ingredients that either stick to
the edge or do not blend well towards the
blender knife. To do so, turn the locking cap
anticlockwise, remove and place the pusher
into the opening. X "Using the pusher" see
page 15
Safety systems
The appliance has various safety systems.
X "Safety systems" see page 17
14
Use
W Risk of injury!
– Do not insert the mains plug until
(Pulse)
/
– Never put your hand in the blender jug
Note: The appliance will only work if the
blender jug has been correctly positioned.
X Fig. B
1. Place the base unit onto a stable and
Important: Never attach the blender jug
without the cushion pad.
2. Place the blender jug on to the cushion
3. Put the desired ingredients into the
4. Put the lid with the locking cap in place
5. Turn the rotary selector in an
6. Plug the mains plug into the mains.
7. Slowly turn the rotary switch clockwise
Note: Using the programme buttons
X "Automatic programmes" see
page 16.
8. Process the ingredients until the desired
9. Turn the rotary selector in an
10. Switch off the appliance with the
all preparations for working with the
appliance are complete and the blender
jug has been correctly positioned on to
the base unit.
once it is in place, and always put the lid
on before using the appliance.
level work surface. Position the cushion
pad on to the base unit, observing the
recess.
pad. Make sure the blender jug is firmly
positioned on the appliance.
blender jug.
and press it firmly.
anticlockwise direction as far as it will go
(zero setting).
Switch on the appliance with the
/ (on/off) switch. All LEDs are lit.
until the desired speed is reached. The
status LED lights up.
consistency is achieved.
anticlockwise direction as far as it will go
(zero setting). Wait until the appliance
comes to a standstill.
/ (on/off) switch. Disconnect the
mains plug.