Recipes - Bosch MMBH6 TW Series Instruction Manual

en

Recipes

Caution!
If a fault cannot be eliminated, please
contact customer service.
Fault
Appliance fails to start up or switches off
while in use. The status display flashes.
Possible causes
– Blender jug is not correctly positioned,
has become detached or has been
removed.
– Rotary selector was not at the zero
setting when switching on or after an
interruption in power.
– The appliance was operating
continuously in manual mode (speed
(min) –
than 5½ minutes.
Remedy
■ Switch off the appliance with the
/ (on/off) switch.
■ Position the blender jug correctly.
■ Turn the rotary selector in an
anticlockwise direction as far as it will go
(zero setting).
■ Switch on the appliance with the
/ (on/off) switch. The status display
lights up.
Fault
Appliance fails to start up or switches off
while in use.
Possible cause
The overload protection device is activated.
Remedy
■ Turn the rotary selector in an
anticlockwise direction as far as it will go
(zero setting).
■ Switch off the appliance with the
/ (on/off) switch. Disconnect the
mains plug.
■ Remove the blender jug.
■ Leave the appliance to cool for approx.
15-20 minutes and then switch it on
again.
■ If the appliance does not start, turn the
appliance upside down. Press the reset
button on the bottom (X Fig. A - 1c).
18
(max)) for longer
■ If the reset button is blocked, leave the
appliance to cool again and try it again
later.
Recipes
Notes:
– In Fig. H, you will find a table with other
application examples. Clean and chop
food before processing. Remove hard
components such as cores and peel.
– The recipes and application examples
can also be carried out without an
automatic programme. To do this, use
the rotary selector to increase the speed
(min) to
from
blend all the ingredients until the desired
consistency is reached.
Berry and honey smoothie
– 400 g frozen raspberries / berry mixture
– 1 banana
– 500 ml milk
– 3 tbsp lemon juice
– 2 tbsp honey
■ Let the raspberries / berry mixture thaw.
■ Cut the peeled banana into pieces.
■ Add the ingredients to the blender jug
and put on the lid with the locking cap.
■ Press the
■ After ending the automatic programme,
serve the smoothie immediately.
Basic soymilk
– 200 g boiled soybeans
– 800 ml warm water (40-50 °C)
– White sugar or honey to sweeten to
preferred taste
■ Add 200 g boiled soybeans to the
blender jug with 800 ml warm water
(40-50 °C). Put on the lid with the
locking cap and press it firmly.
■ Press the
■ Once the program has finished, serve
the soymilk and add sugar or honey to
sweeten.
(max) and
(Smoothie) button.
(Soymilk) button