Bosch MMBH6 TW Series Instruction Manual page 15

11. Remove the blender jug. Remove
the lid.
12. Pour the blended food into another
container.
Clean all parts. X "Cleaning and
maintenance" see page 17
Adding more ingredients
X Fig. C
1. Turn the locking cap in an anticlockwise
direction and remove.
2. Add more chopped or liquid ingredients
through the opening, remembering to
observe the maximum capacity.
3. Put on the locking cap and tighten it by
turning in a clockwise direction.
4. Process the ingredients until the desired
consistency is achieved.
X Fig. D
Adding larger quantities:
1. Turn the rotary selector in an
anticlockwise direction as far as it will go
(zero setting). Wait until the appliance
comes to a standstill.
2. Switch off the appliance with the
/ (on/off) switch. Disconnect the
mains plug.
W Risk of injury!
Never remove the lid while the appliance is
plugged in.
3. Remove the lid.
4. Add the extra ingredients.
5. Replace the lid.
6. Plug the mains plug into the mains.
Switch on the appliance with the
/ (on/off) switch. All LEDs are lit.
7. Slowly turn the rotary switch clockwise
until the desired speed is reached. The
status LED lights up.
8. Process the ingredients until the desired
consistency is achieved.
Using the pusher
W Risk of injury!
Never use the pusher without the lid
attached!
X Fig. E
1. Turn the locking cap in an anticlockwise
direction and remove.
2. Place the pusher provided into the
opening.
3. Push the ingredients with the pusher
towards the blender knife by guiding the
pusher along the corners and sides of
the blending jug.
4. Then remove the pusher again
immediately. Put on the locking cap
and tighten it by turning in a clockwise
direction.
Note: Using the pusher can considerably
improve the quality of the blending result.
Using the Pulse function
■ With the appliance switched on, press
(Pulse) button down and hold.
the
/
(Pulse) button is
■ While the
/
pressed, the appliance will run at
maximum speed.
■ Release the
/
The appliance will start again with the
previously selected speed.
Note: While an automatic programme is
running, the Pulse function cannot be used.
Use
(Pulse) button.
en
15