Before Using The Appliance For The First Time; Symbols And Markings; Parts And Operating Controls - Bosch MMBPP3P4CN Instruction Manual

en

Before using the appliance for the first time

Before using the appliance
for the first time
Before the new appliance can be used,
it must be fully unpacked, cleaned and
checked.
Caution!
Never operate a damaged appliance!
■ Remove the base unit and all
accessories from the packaging and
dispose of all packing materials.
■ Check that all the parts are present and
examine them for obvious damage.
X Fig. A
■ Thoroughly clean and dry all parts
before using for the first time.
X "Cleaning and maintenance" see
page 17

Symbols and markings

Symbol Meaning
Do not expose the blender
jug to temperatures above
80°C.
Warnings on the lid
■ Do not use the appliance
unless this cover is
correctly attached
■ Do not expose the blender
jug to temperatures above
80°C
Warning on the motor block
■ Do not operate without
the rubber pad
14

Parts and operating controls

High-speed motor block
The blender is equipped with a high-speed
motor with a motor speed of up to 45000
revolutions per minute. This not only
provides particularly fast and fine blending
results but also makes it possible to heat
food. Using the 浓汤 (Soup) automatic
programme, for example, a hot soup can be
made from cold ingredients.
Note: At the 最大 (max) speed setting, the
blender runs at the highest speed when
using the 脉冲 (Pulse) button and with
certain automatic programmes. In order to
prevent unwanted heating of food, process
the ingredients for a shorter time or at a
lower speed.
开/关 (on/off) switch
To switch the appliance on and off.
Status display
To display the appliance status and as
a mark for the zero setting of the rotary
selector.
Display
Display lights up: appliance is switched
on and ready for use
Display flashes:
– fault in the appliance
– Blender jug is not correctly positioned
or has become detached
– Rotary selector not at zero setting
when switched on
– after interruption of the power supply
– longer than 5½ minutes of continuous
operation (manual mode)
Rotary selector
For continuous adjustment of the blender
knife speed.
Settings
Zero setting (mark points to the status
display) = standstill
最小 (min)
Lowest speed
最大 (max) Highest speed