Installation Instruction; Select The Best Location - Panasonic CS-BE35TKE-1 Service Manual

11. Installation Instruction

11.1 Select the Best Location

11.1.1 Indoor Unit

Do not install the unit in excessive oil fume area
such as kitchen, workshop and etc.

There should not be any heat source or steam
near the unit.

There should not be any obstacles blocking the air
circulation.

A place where air circulation in the room is good.

A place where drainage can be easily done.

A place where noise prevention is taken into
consideration.

Do not install the unit near the door way.

Ensure the spaces indicated by arrows from the
wall, ceiling, fence or other obstacles.

Installation height for the indoor unit is
recommended at 2.5 m.
11.1.2 Outdoor Unit

If an awning is built over the unit to prevent direct
sunlight or rain, be careful that heat radiation from
the condenser is not obstructed.

There should not be any animal or plant which
could be affected by hot air discharged.

Keep the spaces indicated by arrows from wall,
ceiling, fence or other obstacles.

Do not place any obstacles which may cause a
short circuit of the discharged air.

If piping length is over the [piping length for
additional gas], additional refrigerant should be
added as shown in the table.
Piping size
Horse Std.
Model Power Length
(HP) (m)
Gas Liquid
FE25***,
1.0HP
BE25***,
DE25***
9.52mm
(3/8")
FE35***,
6.35mm
. 1 H 5 P 5
BE35***,
(1/4")
DE35***
12.7mm
FE50*** 2.0HP
(1/2")
Example: For FE25***
If the unit is installed at 10 m distance, the quantity of
additional refrigerant should be 37.5 g .... (10-7.5) m x
15 g/m = 37.5 g.
Min. Max.
Max. Additional Length
Piping Piping
Elevation Refrigerant for add.
Length Length
(m) (g/m)
(m) (m)
15 3 15 15
5 1 3 5 1 5 1
15 3 20 20
11.1.3 Indoor/Outdoor Unit Installation
Diagram
Piping direction
Right
Right
Rear
Right
bottom
50 mm
or more
Insulation of piping connections
• Carry out insulation after
checking for gas leaks and
secure with vinyl tape.
Attaching the remote control holder to the wall
Remote
control 3
It is advisa ble to
avoid more than 2
blockage direction s.
For better ventilation
& multiple-outdoor
installation, please
consult autho rized
dealer/specialist.
• This illustration is for
explanation purposes only.
The indoor unit will actually
face a different way.
Piping
gas
(m)
7.5
7 5 .
7.5
24
Attention not to bend
(Front side) up drain hose
Left Left
Rear
Left bottom
(Left and right are identical)
Vinyl tape
6
Remote control holder fixing screws
Remote control holder 5
Installation pa rts you
should purchase ( )
Installation plate 1
Bushing-Sleeve ( )
Sleeve ( )
Putty ( )
(Gum Type Sealer)
Bend the pipe as
closely on the wall as
possible, but be careful
that it doesn't break.
Power supply cord ( )
Vinyl tape (wide) ( )
• Apply after carrying
out a drainage test.
• To carry out the
drainage test,
remove the air filters
and pour water into
the heat exchanger.
Saddle ( )
Connection cable ( )
Liquid side piping ( )
Gas side piping ( )
Additional drain hose ( )