Installation Instruction; Select The Best Location - Panasonic CS-S9TKV Service Manual

10. Installation Instruction

10.1 Select The Best Location

10.1.1 Indoor Unit

Do not install the unit in excessive oil fume area
such as kitchen, workshop and etc.

There should not be any heat source or steam
near the unit.

There should not be any obstacles blocking the air
circulation.

A place where air circulation in the room is good.

A place where drainage can be easily done.

A place where noise prevention is taken into
consideration.

Do not install the unit near the door way.

Ensure the spaces indicated by arrows from the
wall, ceiling, fence or other obstacles.

Installation height for indoor unit must be at least
2.5 m.
10.1.2 Outdoor Unit

If an awning is built over the unit to prevent direct
sunlight or rain, be careful that heat radiation from
the condenser is not obstructed.

There should not be any animal or plant which
could be affected by hot air discharged.

Keep the spaces indicated by arrows from wall,
ceiling, fence or other obstacles.

Do not place any obstacles which may cause a
short circuit of the discharged air.

If piping length is over the [piping length for
additional gas], additional refrigerant should be
added as shown in the table.
Piping size
Horse Std.
Model
Power Length
(HP) (m)
Gas Liquid
9.52mm
S9*** 1.0HP
(3/8")
S12*** 1.5HP 12.7mm
6.35mm
5
(1/4")
(1/2")
S 1 * 8 * * 2 0 . H P
15.88mm
S24*** 2.5HP
(5/8")
Example: For S9***
If the unit is installed at 10 m distance, the quantity of
additional refrigerant should be 38 g .... (10-7.5) m x
15 g/m = 38 g.
Min. Max.
Max. Piping Piping Additional
Elevation Length Length Refrigerant
(m) (m)
(m) (g/m)
5 3 15 15
5 3 15 15
0 2 3 0 3 5 1
15 3 20 20
10.1.3
Piping direction
Right
Right
Rear
Right
bottom
50 mm
or more
Insulation of piping connections
• Carry out insulation after
checking for gas leaks and
secure with vinyl tape.
Attaching the remote control holder to the wall
Remote
control 3
Floor
It is advisable to avoid
more than 2 blockage
directions. For better
ventilation & multiple-
outdoor installation,
please consult
authorized dealer/
specialist.

Piping This illustration is for explanation purposes only.
Length
The indoor unit will actually face a different way.
for add.
gas
(m)
7.5
7.5
0 1
10
50
Indoor/Outdoor Unit Installation
Diagram
Attention not to bend
(Front side) up drain hose
Left
Left
Rear Left bottom
(Left and right are identical)
Vinyl tape
6
Remote control holder fixing screws
Remote control holder 5
Installation parts you
should purchase ( )
Installation plate 1
Bushing-Sleeve ( )
Sleeve ( )
Putty ( )
(Gum Type Sealer)
Bend the pipe as
closely on the wall as
possible, but be careful
that it doesn't break.
Power supply cord ( )
( )
Vinyl tape (wide)
• Apply after carrying
out a drainage test.
• To carry out the
drainage test,
remove the air filters
and pour water into
the heat exchanger.
Saddle ( )
Connection cable ( )
Liquid side piping ( )
Gas side piping ( )
Additional drain hose ( )
Control Board cover