Table of Contents
Advertisement
C. Igniter Installation and Grounding
Note: Before installing ignition system, ensure that gas valves are closed and gas
is disconnected for safety.
1. A grounding wire is included with your burner as shown
above. This can be plugged into either port on the back
side of the sparker.
2. A spark wire hangs from the electrode at the end of the burner (also above). This can be plugged
into the remaining open port on the back side of the sparker to complete igniter hookup.
Note: It doesn't make a difference which port the wires are plugged into, as long as they are both
plugged in.
A battery (AAA type) should be installed in the igniter before use. The battery's positive end (+)
should face outward when installed.
Page | 10
(Or other thin surface)
Orange wire used ONLY for
optional Automatic Ignition kit
www.outdoorrooms.com
Spark
Ground
Spark
Spark
Ground
Ground
Spark
er
Crystal Fire 42435 REV P 6-1-17
Advertisement
Table of Contents
