Driving The Tractor And Mower - Schulte GX-150 Operator's Manual

Rotary cutter
Table of Contents

Advertisement

Use extreme care when lowering or unfolding the implement's wings.
bystanders are close by or underneath the wings. Allow ample clearance around the
implement when folding or unfolding the wings. Use extreme caution around buildings or
overhead power lines.

9.4 Driving the Tractor and Mower

Start off driving at a slow speed and gradually increase your speed while maintaining complete control of the
tractor and mower. Moving slowly at first will also prevent the tractor from rearing up and loss of steering
control. The tractor should never be operated at speeds that cannot be safely handled or which will prevent the
operator from stopping quickly during an emergency. If the power steering or engine ceases operating, stop
the tractor immediately as the tractor will be difficult to control.
Drive the tractor with the 3-Point lift arms in the raised position and lock the control lever in the transport detent
position to prevent damage to the mower driveline and tongue when turning.
Perform turns with the tractor and mower at slow speeds to determine how the tractor with an attached mower
handles a turn. Determine the safe speed to maintain proper control of the tractor when making turns. When
turning with a towed implement, the overall working length of the unit is increased. Allow additional clearance
for the mower when turning, especially if the wings are lowered.
To avoid overturns, drive the tractor with care and at safe speeds, especially when operating over rough
ground, crossing ditches or slopes, and turning corners. Rear tractor tire spacing should be increased when
working on inclines or rough ground to reduce the possibility of tipping.
Use extreme caution when operating on steep slopes. Keep the tractor in a low gear when going downhill. DO
NOT coast or free-wheel downhill.
GX-150 03/21
© 2021 Alamo Group Inc.
OPERATION
(S3PT-05)
Operation Section 4-30
Make sure no

Advertisement

Table of Contents
loading

Table of Contents