Schulte GX-150 Operator's Manual page 68

OPERATION
Figure Ops-1014 shows a GX-150 cutter set-up with clockwise blade rotation on the center section and right
wing, and counter clockwise blade rotation on the left wing.
EXAMPLES:
If there is material buildup in Sections B + E, raise shrouds 1+ 5 to allow some material out sooner.
If more material is found in Sections A + B and less in C + D, then shroud 2 can be lowered to allow less
material from the enter section.
If a lot of material is found in sections A + F, then lower the rear end of shrouds 1 + 5 to bring more material
around towards the center.
GX-150 03/21 Operation Section 4-14
© 2021 Alamo Group Inc.