Table of Contents
Advertisement
If sliding members are allowed to dry out to the point where the two halves cannot slip
freely, damage to the rotary cutter or tractor may occur.
IMPORTANT: Scan this QR Code with your smart phone to link to the ADMA
Driveline Safety Manual for more information on the safe use of a driveline during
normal operation and maintenance. Or type in your internet browser the following
web address: www.algqr.com/dme
SLIP CLUTCHES
Each of the drivelines on the Schulte cutter is equipped with a slip clutch.
Everyone of these slip clutches are pre-set and run-in by the Schulte supplier, so they should not be adjusted
by the dealer or end user.
Clutches should be replaced when they are no longer working effectively. When installing the new clutch,
please make sure the spring height is set at the correct setting of 27.5mm.
New friction linings are 3.6mm (0.14 in.) thick. Replacement is recommended when linings wear below a
thickness of 2mm (0.08").
GX-150 03/21
© 2021 Alamo Group Inc.
MAINTENANCE
Ops-0009-MISC
Maintenance Section 5-7
Advertisement
Table of Contents
