Tire Spacing; Getting On And Off The Tractor; Boarding The Tractor - Schulte GX-150 Operator's Manual

Never operate the Tractor and Mower if the Implement input driveline is directly connected
to the Tractor transmission. Tractor braking distances can be substantially increased by the
momentum of the rotating Mower blades driving the Tractor transmission even though the
Tractor clutch has been disengaged. Install an over running clutch between the Tractor
PTO and the Mower driveline to prevent this potentially dangerous situation.

2.8 Tire Spacing

Tractor tires should be set a minimum of 60" (1.5
m) apart measured from inside of tire to inside of
tire, or maximum width possible. Refer to the
tractor Operator's Manual
authorized dealer for instructions to change
tractor tire spacing. OPS-R-0062
2.9

3. GETTING ON AND OFF THE TRACTOR

Before getting onto the tractor, the operator must read and completely understand the implement and tractor
operator manuals. If any part of either manual is not completely understood, consult an authorized dealer for
a complete explanation. OPS-U-0007
Do not mount or dismount the Tractor while the tractor is moving. Mount
the Tractor only when the Tractor and all moving parts are completely
stopped.

3.1 Boarding the Tractor

Use both hands and equipped handrails and steps for support when boarding the tractor. Never use control
levers for support when mounting the tractor. Seat yourself in the operator's seat and secure the seat belt
around you.
Never allow passengers to ride on the tractor or attached equipment. Riders can easily fall off and be seriously
injured or killed from falling off and being ran over. It is the operator's responsibility to forbid all extra riders at
all times. OPS-U- 0008
GX-150 03/21
© 2021 Alamo Group Inc.
OPERATION
or consult an
(SG-12)
Operation Section 4-6
(S3PT-16)