Table of Contents
Advertisement
CAUTION: Do not set the fryer with its back flat against the wall. It will not operate
properly unless there is at least 3" breathing space behind fryer.
WARNING: A factory authorized agent should handle all maintenance and repair.
Before doing any maintenance or repair, contact APW Wyott.
WARNING: Never clean any electrical unit by immersing it in water. Turn off before
cleaning surface.
WARNING: An earthing cable must connect the appliance to all other units in the
complete installation and from there to an independent earth connection.
NOTICE: The unit when installed must be electrically grounded and comply with
local codes, or in the absence of local codes, with the national electrical code ANSI/
NFPA70- latest edition. Canadian installation must comply with CSA-STANDARD
C.22.2 Number 0 M1982 General Requirements-Canadian Electrical Code Part II,
109-M1981- Commercial Cooking Appliances.
WARNING: SHOCK HAZARD - De-energize all power to equipment before cleaning
the equipment.
NOTICE: This product is intended for commercial use only. Not for household use.
NOTICE: Local codes regarding installation vary greatly from one area to another.
The National Fire Protection Association, Inc. states in its NFPA96 latest edition that
local codes are "Authority Having Jurisdiction" when it comes to requirement for
installation of equipment. Therefore, installation should comply with all local codes.
CAUTION: This product when stacked, has more than one power supply connection
point. Disconnect all power supplies before servicing.
CAUTION: Suitable for installation on combustible floor when installed with legs or
casters provided.
WARNING: SHOCK HAZARD - Do not open any panels that require the use of tools.
Immediately Inspect For Shipping Damage
All containers should be examined for damage before and during unloading. The freight carrier has
assumed responsibility for its safe transit and delivery. If equipment is received damaged, either
apparent or concealed, a claim must be made with the delivering carrier.
A) Apparent damage or loss must be noted on the freight bill at the time of delivery. It must then be
signed by the carrier representative (Driver). If this is not done, the carrier may refuse the claim. The
carrier can supply the necessary forms.
B) Concealed damage or loss if not apparent until after equipment is uncrated, a request for
inspection must be made to the carrier within 15 days. The carrier should arrange an inspection. Be
certain to hold all contents and packaging material.
Installation and start-up should be performed by a qualified installer who thoroughly read, understands
and follows these instructions.
3
Advertisement
Table of Contents
