Table of Contents
Advertisement
SECTION
ITEM . . . . . . . . . . . . . . . . . . PAGE
1
Safety Information . . . . . . . . . . . . 2
2
General Information . . . . . . . . . . 4
3
Description . . . . . . . . . . . . . . . . . 4
4
5
Thermostat Calibration . . . . . . . . 5
6
Maintenance . . . . . . . . . . . . . . . . 6
7
Cleaning . . . . . . . . . . . . . . . . . . . 8
APW Wyott takes pride in the design and quality of our products. When used as intended and with
proper care and maintenance, you will experience years of reliable operation from this equipment. To
ensure best results, it is important that you read and follow the instructions in this manual carefully.
Installation and start-up should be performed by a qualified installer who thoroughly read, understands
and follows these instructions.
If you have questions concerning the installation, operation, maintenance or service of this product,
write Technical Service Department: APW Wyott Foodservice Co., Inc., 1307 N Watters Rd. Suite 180,
Allen, TX 75013.
CAUTION: These models are designed, built, and sold for commercial use. If these
models are positioned so the general public can use the equipment make sure that
cautions, warnings, and operating instructions are clearly posted near each unit so
that anyone using the equipment will use it correctly and not injure themselves or
harm the equipment.
WARNING: Check the data plate on this unit before installation. Connect the unit
only to the voltage and frequency listed on the data plate. Connect only to 1 or 3
phase as listed on the data plate.
WARNING: Electrical and grounding connections must comply with the applicable
portions of the national electrical code and/or other local electrical codes.
WARNING: Disconnect device from electrical power supply and place a Tag
Out-Lockout on the power plug, indicating that you are working on the circuit.
WARNING: Install per the spacing requirements listed in the installation section of this
manual. We strongly recommend having a competent professional install the equipment.
A licensed electrician should make the electrical connections and connect power to the
unit. Local codes should always be used when connecting these units to electrical power.
In the absence of local codes, use the latest version of the National Electrical Code.
WARNING: This device should be safely and adequately grounded in accordance with
local codes, or in the absence of local codes, with the National Electrical code, ANSI/
NFPA 70, Latest Edition to protect the user from electrical shock. It requires a grounded
system and a dedicated circuit, protected by a fuse or circuit breaker of proper size and
rating. Canadian installation must comply with the Canadian Electrical Code, CSAC22.2,
as applicable.
TABLE OF CONTENTS
SECTION
8
9
10
11
12
13
1 . SAFETY PRECAUTIONS
2
ITEM . . . . . . . . . . . . . . . . . . PAGE
Service . . . . . . . . . . . . . . . . . . . . 8
Troubleshooting Guide . . . . . . . 10
Suggested Temperature &
Times . . . . . . . . . . . . . . . . . . . . . 11
Exploded Views . . . . . . . . . . . . . 11
Wiring Diagram . . . . . . . . . . . . . 15
Warranty . . . . . . . . . . . . . . . . . . 17
Advertisement
Table of Contents
