Table of Contents
Advertisement
Available languages
Available languages
You can set the various functions by pressing the keys
(see the keys function chapter).
The remote control supplied with the device is
designed to provide maximum sturdiness and
exceptional functionality, but should nonetheless be
handled with caution.
Avoid:
-
leaving it exposed to rain, spilling liquid on the
keyboard or dropping it in water
-
bumping it forcefully or letting it fall on hard surfaces
-
leaving it exposed to direct sunlight
Inserting the battery
Use only a dry 3V lithium battery CR2025 (included) with
the remote control. Used batteries must be disposed of
appropriately (WEEE) through special waste collection
centres provided by the local authorities.
Functional description
Main switch-on and operation
To control the device with the remote control or touch-
screen display, make sure you have enabled the main
switch on the power line (the technician who installed
the device can help you locate the switch), or introduce
a power plug on the device, plugging it into the system's
socket.
EN / 42
-
placing obstacles between the remote control and the
device while you are using the remote.
Moreover:
-
if other devices are being used within the premises that
are operated by remote control (TVs, radios, stereos,
etc.), you might experience some interference
-
electronic and fluorescent lamps can interfere with
communications between the remote control and the
device.
-
remove the battery in case of prolonged inactivity of
the remote control.
To insert the battery, open the slot on the bottom of the
remote control. Make sure to insert the battery according
to the +/- polarity. Close the cover after inserting the
battery.
After you perform these steps, you can operate the system
either by pressing the symbols on the touch-screen display
or using the remote control. To send commands to the
indoor unit, point the front of the remote towards the unit's
display. The buzzer will emit a beep and a message will
appear on the display to confirm that the command has
been enabled. The maximum range to send commands is
about 8 metres.
Advertisement
Table of Contents
