Table of Contents
Advertisement
Available languages
Available languages
High wall mount
-
For smooth installation, especially if you want to
set-up the system before you install the device, we
recommend installing a built-in cistern, as shown in the
figure;
-
If you do not complete installation of the device when
installing the cistern, leave the water and condensate
drain pipes hanging loose, so that you can later make
the connections without joints;
-
When you finally install the device, it will be possible
to connect the cooler-radiator with a 90° fitting and
socket with eurokonus connection;
A
built-in cistern
B
connecting water pipelines
D
-
another option if you can comfortably bend the
pipeline (which will depend on the depth of the
installed cistern) is to install the eurokonus connection
inside the pipeline;
-
pay attention to the tilt angle of the condensate drain
pipe, which must rest be laid on the lowermost part of
the cistern so that the pipe's height never exceeds the
height of the cooler-radiator drain connection;
-
for the installation heights, refer to the installation
template supplied with the device and which is shown
in the following pages.
C
condensation drainage pipe
D
cooler-radiator
A
C
B
EN / 33
Advertisement
Table of Contents
