Table of Contents
Advertisement
Available languages
Available languages
CONTROL PANEL INSTALLATION AND CONNECTION
Touchpad and Remote control
Fancoil DC Inverter for wall installation with autonomous
electronic control on board machine and remote control.
Before you connect the cooler-radiator, make sure
that:
-
the voltage and frequency match the values on the
device's nameplate.
-
The power line has an efficient ground connection and
is appropriately sized for the unit's maximum current
absorption (minimum cable section: 1.5 mm
If you need to replace the power cable, contact only
the technical customer service or qualified staff, in
H2
Water temperature probe 10 kΩ
M1
Fan motor DC inverter
Water solenoid valve
Y1
(230V/50Hz 1A powered output)
230V/50Hz electrical power supply
L-N
connection
Boiler consent output
BO
(free contact max 1A)
Chiller consent output
CH
(free contact max 1A)
AIR
Air probe
DIS
Control panel (display) wiring
SM
Step Motor Connector
EN / 40
compliance with the applicable national laws.
You can use a cable embedded in the wall in the position
traced with the installation template to make the electrical
connection (recommended connection for devices
installed in the upper part of the wall).
In any case, you must check that the power supply is
protected against overload and/or short-circuits.
2
).
In order to prevent any risk of electric shock, it is essential
to disconnect the main circuit breaker before making any
electrical connections and performing maintenance on the
equipment.
H2 AIR
SM
Advertisement
Table of Contents
