Erasing Homelink; In Case A Problem Occurs; Rear View Camera (If Equipped) - Subaru 2011 Tribeca Owner's Manual

3. Press and hold the hand-held trans-
mitter button. The HomeLink
light will flash, first slowly and then rapidly.
4. When the indicator light begins to flash
rapidly, release both buttons.
The programming for the previous device
is now erased and the new device can be
operated by pushing the HomeLink
button.
& Erasing HomeLink
®
memory
NOTE
. Performing this procedure erases
the memory of all the preprogrammed
buttons simultaneously. The memory
of individual buttons cannot be erased.
. It is recommended that upon the
sale of the vehicle, the memory of all
®
programmed HomeLink
erased for security purposes.
1. Press and hold the two outside buttons
until the indicator light begins to flash
(after 20 seconds).
2. Release both buttons.
& In case a problem occurs
®
indicator
If you cannot activate a device using the
corresponding HomeLink
programming, contact HomeLink at
www.homelink.com or call 1-800-355-
3515 for assistance.
®
button
buttons be
Rear view camera (if
equipped)
®
button after
A rear view camera is attached to the rear
gate. When the ignition switch is "ON" and
the select lever is set to "R", the rear view
camera automatically displays the rear
view image behind the vehicle on the
navigation monitor or on the inside mirror.
. Since the rear view camera uses
a wide-angle lens, the image on
the monitor is different from the
actual view in terms of distance.
. Since the range of the image on
the monitor is limited, you should
always check the rear view and
6-21
Interior equipment
WARNING
– CONTINUED –