Garage Door Opener Programming In The U.s.a - Subaru 2011 Tribeca Owner's Manual

6-18
Interior equipment
NOTE
. After programming your HomeLink
Wireless Control System for the de-
sired devices, retain the hand-held
transmitters for further programming
or device testing in the event of a
problem.
. It is recommended that you insert a
new battery in the hand-held transmit-
ter of a device to ensure correct
programming.
& Garage door opener pro-
gramming in the U.S.A.
NOTE
When programming the HomeLink
Wireless Control System for a garage
door opener, it is suggested that you
park the vehicle outside the garage.
1. Unplug the motor of the garage door
opener from the outlet.
NOTE
®
If any of the HomeLink
already programmed for other devices,
skip step 2 because it clears the
memory of all the three buttons.
®
2. Press and hold the two outside
®
HomeLink
begins to flash (after 20 seconds). Re-
®
lease both buttons.
3. Hold the end of the garage door
opener's hand-held transmitter between
1 and 3 inches (25 and 76 mm) away from
the HomeLink
visor, keeping the indicator light in view.
buttons are
buttons until the indicator light
®
buttons on the driver's sun
4. Using both hands, simultaneously
push the hand-held transmitter button
and the desired HomeLink
NOT release the buttons until step 5 has
been completed.
5. Hold down both buttons until the
®
HomeLink indicator light flashes, first
slowly then rapidly. When the indicator
light flashes rapidly, both buttons may be
released. (The rapidly flashing light indi-
cates successful programming of the new
frequency signal.)
6. Press and hold the programmed but-
ton and check the HomeLink
light. If the indicator light stays on con-
tinuously, your garage door should acti-
vate and the programming is completed.
If the indicator light flashes rapidly for 2
seconds and then stays on continuously,
®
button. DO
®
indicator