Subaru 2011 Tribeca Owner's Manual page 292

3. The crossbar with a 150 lbs (68 kg)
load label attached onto it is the front
crossbar. An arrow is marked on the back
of the front crossbar for correct installa-
tion. Install the front crossbar so that the
arrow faces the front of the vehicle.
1) 12 in (300 mm)
4. Install the front crossbar so that the
crossbar end supports are located ap-
proximately 12 in (300 mm) rearward from
the joints between the roof rails and the
front roof rail supports.
Driving tips
1) Lower clamp
®
2) T-30 torx head screw
5. Tighten the lower clamps onto the
crossbar. Using a torque wrench, loosely
®
tighten the T-30 torx head screws.
NOTE
It may be necessary to squeeze the
lower clamp and the end support
together to compress the pads and
gain a better alignment of the pieces
while trying to start the screw. Use care
not to cross-thread the screw in the
insert.
– CONTINUED –
8-15