Subaru 2005 Legacy Owner's Manual page 438

A) Lower clamp
B) T-30 torx® head screw
5. Tighten the lower clamps onto the crossbar. Using
a torque wrench, loosely tighten the T-30 torx® head
screws.
NOTE
It may be necessary to squeeze the lower clamp
and the end support together to compress the
pads and gain a better alignment of the pieces
while trying to start the screw. Use care not to
crossthread the screw in the insert.
6. Adjust the alignment of the crossbar on the roof
rails, and if available, use a T-30 torx® bit and torque
wrench and tighten the T-30 torx® head screws to 30
to 35 lbf·in (3.4 to 4.0 N·m, 0.35 to 0.41 kgf·m) of
torque (or tighten securely with the torx® wrench pro-
vided).
Driving tips
– CONTINUED –
8-25