Installation Of Child Restraint Systems By Use Of Lower And Tether Anchorages (Latch) - Subaru 2005 Forester Owner's Manual

Hide thumbs Also See for 2005 Forester:
Table of Contents

Advertisement

4. To remove the booster seat, press the release but-
ton on the seatbelt buckle and allow the belt to retract.
Never use a belt that is twisted or reversed. In
an accident, this can increase the risk or sever-
ity of injury to the child.
Never place the shoulder belt under the
child's arm or behind the child's back. If an ac-
cident occurs, this can increase the risk or se-
verity of injury to the child.
The seatbelt should fit snugly in order to pro-
vide full restraint. Loose fitting belts are not as
effective in preventing or reducing injury.
Place the lap belt as low as possible on the
child's hips. A high-positioned lap belt will in-
crease the risk of sliding under the lap belt and
of the lap belt sliding up over the abdomen, and
both can result in serious internal injury or
death.
Make sure the shoulder belt is positioned
across the center of child's shoulder. Placing
the shoulder belt over the neck may result in
neck injury during sudden braking or in a colli-
sion.
US1586BA
Installation of child restraint systems
by use of lower and tether anchorages
(LATCH)
Child restraint systems and seatbelts can be-
come hot in a vehicle that has been closed up
in sunny weather; they could burn a small child.
Check the child restraint system before you
place a child in it.
Do not leave an unsecured child restraint
system in your vehicle. Unsecured child re-
Seat, seatbelt and SRS airbags
– CONTINUED –
1-45

Advertisement

Table of Contents
loading

Table of Contents