Turn Signal Indicator Lights; High Beam Indicator Light; Cruise Control Indicator Light (If Equipped); Cruise Control Set Indicator Light (If Equipped) - Subaru 2005 Forester Owner's Manual

Turn signal indicator lights

These lights show the operation of the turn signal or
lane change signal.
If the indicator lights do not blink or blink rapidly, the
turn signal bulb may be burned out. Replace the bulb
as soon as possible. Refer to the "Replacing bulbs"
section in chapter 11.

High beam indicator light

This light shows that the headlights are in the high
beam mode.
This indicator light also comes on when the headlight
flasher is operated.
Cruise control indicator light (if
equipped)
The cruise control indicator light comes on when the
ignition switch is turned to the "ON" position and goes
out after about three seconds.
This light comes on when the "CRUISE" main switch
is pressed.
NOTE
If you move the cruise control lever while turn-
ing the ignition switch "ON", the cruise control
function is deactivated and the cruise control indi-
cator light flashes. To reactivate the cruise control
function, turn the ignition switch back to the
"ACC" or "LOCK" position, and then turn it again
to the "ON" position.
If this indicator light and the "
light flash simultaneously during driving, have the
vehicle checked by your nearest SUBARU dealer.
Cruise control set indicator light (if
equipped)
The cruise control set indicator light comes on when
the ignition switch is turned to the "ON" position and
goes out after about three seconds.
This light comes on when vehicle speed has been set.
Instruments and controls
" indicator
– CONTINUED –
3-21