Absolute Paths - Nokia 7210 Configuration Manual

CLI Usage

2.7.4 Absolute Paths

CLI commands can be executed in any context by specifying the full path from the
CLI root. To execute an out-of-context command enter a forward slash "/" or
backward slash "\" at the beginning of the command line. The forward slash "/" or
backward slash "\" cannot be used with the environment alias command.The
commands are interpreted as absolute path. Spaces between the slash and the first
command will return an error. Commands that are already global (such as ping,
telnet, exit, back, etc.) cannot be executed with a forward slash "/" or backward slash
"\" at the beginning of the command line.
*A:ALA-12# configure router
*A:ALA-12>config>router# interface system address 1.2.3.4
*A:ALA-12>config>router# /admin save
*A:ALA-12>config>router# \clear router interface
*A:ALA-12>config>router#
The command may or may not change the current context depending on whether or
not it is a leaf command. This is the same behavior the CLI performs when CLI
commands are entered individually, for example:
*A:ALA-12# admin
*A:ALA-12>admin# save
or
*A:ALA-12# admin save
*A:ALA-12#
Note that an absolute path command behaves the same as manually entering a
series of command line instructions and parameters.
For example, beginning in an IES context service ID 4 (IES 4),
CLI Syntax:
behaves the same as the following series of commands.
Example:
36
config>service>ies> /clear card 1
Example:config>service>ies>exit all
clear card 1
configure service ies 4 (returns you to your starting
point)
config>service>ies
© 2021 Nokia.
Use subject to Terms available at: www.nokia.com
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
3HE 17358 AAAB TQZZA