Entering Edit Mode - Nokia 7210 Configuration Manual

7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
----------------------------------------------
*A:SAS-M2>config>system>sync-if-timing#
6.11.5.1.5
The following is a sample CLI configuration for the 7210 SAS-Sx/S 1/10GE.
*7210SAS>config>system>sync-if-timing# info detail
----------------------------------------------
----------------------------------------------
*7210SAS>config>system>sync-if-timing#
6.11.5.2
To enter edit mode and edit timing references, enter the begin keyword at the
config>system>sync-if-timing# prompt.
Use the following CLI syntax to enter the edit mode.
CLI Syntax:
The following is a sample error message that is displayed if you try to modify sync-
if-timing parameters without entering the begin keyword.
A:ALA-12>config>system>sync-if-timing>ref1# source-port 2/1/1
MINOR: CLI The sync-if-timing must be in edit mode by calling begin before any
changes can be made.
MINOR: CLI Unable to set source port for ref1 to 2/1/1.
3HE 17358 AAAB TQZZA
exit
exit
ptp
shutdown
no ql-override
exit
no revert
CLI Syntax for 7210 SAS-Sx/S 1/10GE:
no ql-selection
ref-order ref1 ref2
ref1
shutdown
no source-port
no ql-override
exit
ref2
shutdown
no source-port
no ql-override
exit
no revert

Entering Edit Mode

config>system>sync-if-timing
begin
Use subject to Terms available at: www.nokia.com
© 2021 Nokia.
System Management
357