1830 Dwdm Shelf Layout And Description - Nokia 7210 Configuration Manual

System Management
Figure 33
In
named using the acronym EC-CW for the 1830 CWDM device, does not require
explicit provisioning. The card type is automatically provisioned when the user
configures the 1830 VWM shelf type.
If the controller card is not present in Slot 1 of the shelf, the 1830 CWDM device
operates as a passive filter and is not managed by the 7210 SAS. The 7210 SAS
provides inventory and equipment management capability only when the controller
card is present in the shelf and connected to the 7210 SAS.
Slot 2 and Slot 3 shown in
cards. The user must provision the cards that populate the slots. The 7210 SAS
software checks to ensure a match between the equipped and provisioned card type;
an event is logged if a mismatch is detected.
6.6.2.2
Figure 34
7210 SAS.
Figure 34
The following information applies to the management of the 1830 DWDM shown in
Figure
306
1830 CWDM Shelf Layout
Slot #1
Power & Control OADM or Mux/Demux (Line card)
Figure 33, Slot 1 is dedicated to the controller card. The controller card, which is

1830 DWDM Shelf Layout and Description

shows the 1830 DWDM shelf and the entities that can be managed by
1830 DWDM Shelf Layout
Slot #1
Power & Control
Slot #2
Power & Control
34.
Use subject to Terms available at: www.nokia.com
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Slot #2
Figure 33 can be equipped with supported CWDM filter
Slot #3
Filter/Amplifier/BPM (Line card)
Slot #4
Filter/Amplifier/BPM (Line card)
© 2021 Nokia.
Configuration Guide
Slot #3
OADM or Mux/Demux (Line card)
3HE 17358 AAAB TQZZA
hw0385
Slot #5
FANS or
1-Wire
hw0386