Table of Contents
Advertisement
installation
Separate grill wall oven & pizza oven
WARNING
caution
NOTE: Dimension "D".
A requirement for all separate grill wall ovens and all Duo ovens – for proper ventilation there must be a gap at the bottom
rear of the cabinet. This must be a full width opening 20mm deep.
Recommended
650 min
Hard wiring detail
1. Remove terminal cover plate from rear panel of appliance.
2. Fit wires through hole in cover plate and make connections
to terminals.
3. Engage wires into plastic clip. Secure plastic clip with two
long silver screws (supplied in separate bag).
4. Replace cover plate onto rear panel.
34 CLEANING YOUR OVEN DOOR Built-in Cooking
561
A
B
D
C
A
Flush fit (mm)
600
Proud fit (mm)
565
Mounting holes
Use black installation
screws supplied
596
B
C
893
581(min)
885
560 (min)
B
(893mm)
D (200mm)
C (581mm)
Flush fit
section view
Second active wire only
required (optional) for
multi-phase products.
Plastic clips
Plastic clip
securing points.
Built-in Cooking INSTALLATION 7
D
20
20
Advertisement
Table of Contents
