Separate Grill Wall Oven & Pizza Oven; Pyrolytic Underbench Oven - Electrolux CVE602 User Manual

installation
Separate grill wall oven & pizza oven
WARNING
caution
NOTE: Dimension "D".
A requirement for all separate grill wall ovens and all Duo ovens – for proper ventilation there must be a gap at the bottom
rear of the cabinet. This must be a full width opening 20mm deep.
561
A
B
D
C
650
min
Hard wiring detail
1. Remove terminal cover plate from rear panel of appliance.
2. Fit wires through hole in cover plate and make connections
to terminals.
3. Engage wires into plastic clip. Secure plastic clip with two
long silver screws (supplied in separate bag).
4. Replace cover plate onto rear panel.
34 CLEANING YOUR OVEN DOOR Built-in Cooking
34 INSTALLATION Built-in Cooking
A B C
Flush fit (mm) 600 893 581(min)
Proud fit (mm) 565 885 560 (min)
Mounting holes
Use black installation
screws supplied
B
(893mm)
596
D (200mm)
C (581mm)
Flush fit
section view
Second active wire only
required (optional) for
multi-phase products.
Plastic clips
Plastic clip
securing points.
installation
Pyrolytic underbench oven-flush fit only
Your underbench oven looks best when the control panel is directly under the benchtop. An upper infill panel may have
to be added if the cooktop placed over the oven is too deep. Refer to cooktop installation instructions for required
clearance between cooktop and oven.
WARNING
caution
NOTE: Dimension "D".
D
A requirement for all pyrolytic clean ovens – for proper ventilation there must be a gap at the bottom rear of the
20
cabinet. This can be a full width opening 20mm deep.
20
upper infill
(if required)
A
D
C
A
Flush fit (mm) 600
B
561
Mounting holes
Use black installation
screws supplied
596
16mm
Flush Fit
(Pyro only)
Cupboard
door
B C D
600 581(min) 20
568mm
Infill
panel
100mm max
for pyro oven
20mm
Oven
600mm
Built-in Cooking INSTALLATION 35