Cleaning Your Oven Door (Pyrolytic Models) - Electrolux CVE611 User Manual

cleaning your oven door
(pyrolytic models)
Cleaning the 4 layer door (Pyrolytic models)
WARNING
caution
Do not lift the door by the handle. Rough handling will cause
glass to break.
Removing the oven door
TIPS & INFORMATION
important
Your oven is equipped with a door that can be disassembled
in order to clean all the panes of glass. Remove the door
before cleaning.
• Open the door fully to access the hinges then rotate the
'stirrups' (highlighted in the image) on both hinges fully to
open position.
• Slowly close the oven door until it is stops against the
'stirrups' (about 30°).
• Hold the oven door with a hand each side and remove it
from the oven by pulling it towards you.
• Lay the oven door with the outer side facing downwards
on something soft and flat (for example a blanket on a
kitchen table) to prevent scratches.
Removing oven door top trim
• Hold the embossed sections of the door columns at each
end and press inwards to release the clips. Remove the
upper door trim by pulling it towards you.
Removing the door glass panels
WARNING
caution
Rough handling, especially around the edges can cause the
glass to break.
• Lift the black bordered glass panel out of the
guide and place on something soft and flat to
prevent scratches.
• Repeat this for the smaller clear glass panels.
• When removing panel 3, ensure that the two rubber spacers
are removed before cleaning. Do not misplace them!
Built-in Cooking CLEANING YOUR OVEN DOOR (PYROLYTIC MODELS) 31
Chamfer to be located in this corner
Chamfer to be loca